Blata MIDIQUADARD Service Manual

M I N I B I K E 2,6

6 345.100.00 345.100.00 347.010.70 7

8 MINIBIKE - 2,6 200.000.00 MINIBIKE 2,6 510.002.00 STARTER COMPLETE ENGINE 510.003.00 STARTER ROPE 110.001.00 ENGINE COMP

LINING 119.008.00 TANK WITH CAP 114.003.01 FRONT LINING, NON VARNISHED 119.009.00 TANK 114.004.00 SADDLE, NON VARNISHED 119.010.00 SCREW CAP 114

916.072.02916.072.0210 916.072.02 916.072.02

ADJUSTING THE BRAKES Small incremental brake adjustment : Free play at the handlebar lever is effected by turning the knurled end on the ca

DISMANTLING AND MOUNTING THE REAR WHEEL, FIG. 5 Unscrew the rear axle nut 920.011.01 and loosen the nuts 920.009.01 on chain tighteners. Shift th

NON USE AND STORAGE PROCEDURE It is recommended to drain out all fuel from the tank and carburetor. Inflate the tires to the working pressure and

SAFETY WARNING Always pay attention to the instructions and safety warnings below This manual contains important safety information and i

SERVICE MANUAL FOR USE AND MAINTENANCE OF MINIBIKE Before starting the operation of your Minibike, read thoroughly these directions. CONTENTS

INTRODUCTION Minibike 2,6 is intended for a drive on closed tracks with even, smooth, and dust-free surface. Both growns - up and children can r

UNPACKING AND BASIC CONTROLS: The Minibike is packed and delivered with folded handlebars and levers mounted on them. After unpacking, set up the

STARTING THE ENGINE To be done only on the starting stand - Fig. 2. After opening the tank filling hole, fill the tank with fuel and close it by s

RIDE After mounting the Minibike and slow turning the acceleration handle, you are starting your ride. Before braking, turn back the acceleration

6